What if the profiles don't turn out nicely in the end?

Don't panic. You solve that easily.

Cladix works with a tooth-hook system where you have per connection can slide 2 mm to the left or right. That gives you 4 mm headroom per profile.

How do you correct this?

Do you come up just short at the end?

1. Temporarily remove some of the installed profiles.
2. Spread the available slack over several profiles.
3. Make the intervals slightly shorter or longer.
4. Reassemble the profiles.

By spreading those small corrections over the facade, you avoid large discrepancies at the end.

The calculation tool makes it easy for you

The Cladix calculation tool already takes this slack into account when calculating your profile distribution.

Nevertheless, a small correction on site sometimes remains necessary, e.g. for slight deviations in wall width or supporting structure.

Thanks to the 2 mm adjustability per hook joint, you catch that without any problem.

With the built-in clearance and clever redistribution of your profiles, you will always end up neatly at the end of your facade.